350-501 Training & Certification Get Latest CCNP Service Provider Updated on Dec 28, 2021
Certification Training for 350-501 Exam Dumps Test Engine
Difficulty in Writing Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies Exam
The Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies certification is one of the most important certifications that applicants can have on their CV. One of the biggest challenges for many candidates is to use the Internet to find so many details that make it impossible for them to believe, which would be beneficial for them to choose the correct materials for their tests.
The Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies test is not simpler and unless well prepared, can prove to be a very tough exam. If competent 350-501 exam dumps are researched and evaluated on 350-501 practice exams, the exam difficulty can be overcome.
However, applicants can clear the examination with the correct concentration and the correct preparatory material. PrepPDF have the most up to date 350-501 dumps pdf that allows a clear understanding of the pattern in questions raised by these dumping aspirants with real certification. The experts track PrepPDF for all the changes in the course. Certification problems also require realistic research, which is an ideal forum to test the knowledge that is collected. For the study content, refer to the links below.
NEW QUESTION 88
Refer to the exhibit:
This output is included at the end of an output that was provided by a device using NETCONF.
What does the code show?
- A. It shows that the running configuration is blank
- B. It shows that the full configuration is being modeled by VANG
- C. It shows NETCONF uses remote procedure calls.
- D. It shows the hostname of the device as rpc-reply
Answer: D
NEW QUESTION 89
Refer to the exhibit:
An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?
- A. Router 1 must be configured with uRPF for the RTBH implementation to be effective.
- B. Router 2 must configure a route to null 0 for network 192 168.1 0/24 for the RTBH implementation to be complete.
- C. Router 1 is the trigger router in a RTBH implementation.
- D. Router 2 is the router receiving the DDoS attack
Answer: B
NEW QUESTION 90 
Refer to the exhibit. What is significant about the number 2 in the configuration?
- A. It is the numeric name of the ACL that contains the list of SNMP managers with access to the agent.
- B. It indicates two SNMP managers can read and write with the agent using community string ciscotest.
- C. It represents the version of SNMP running.
- D. It dictates the number of sessions that can be open with the SNMP manager.
Answer: A
Explanation:
Section: Automation and Assurance
NEW QUESTION 91
Drag and drop the functionalities from the left onto the correct target fields on the right.
Answer:
Explanation:
NEW QUESTION 92
Refer to the exhibit:
A network administrator wants to enhance the security for SNMP for this configuration.
Which action can the network administrator implement?
- A. Re-configure to use SNMPv3.
- B. Add a community string to the existing entry
- C. Maintain the configuration but switch to an encrypted password for device access through SSH
- D. Re-configure to use SNMPv2 with MD5 authentication
Answer: A
NEW QUESTION 93
Drag and drop the functions from the left onto the Path Computation Element Protocol roles on the right.
Answer:
Explanation:
NEW QUESTION 94
An engineer is setting up overlapping VPNs to allow VRF ABC and XYZ to communicate with VRF CENTRAL but wants to make sure that VRF ABC and XYZ cannot communicate. Which configuration accomplishes these objectives?
A)
B)
C)
- A. Option B
- B. Option C
- C. Option A
Answer: A
NEW QUESTION 95
Refer to the exhibit:
An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?
- A. Router 2 must configure a route to null 0 for network 192 168.1 0/24 for the RTBH implementation to be complete.
- B. Router 1 must be configured with uRPF for the RTBH implementation to be effective.
- C. Router 1 is the trigger router in a RTBH implementation.
- D. Router 2 is the router receiving the DDoS attack
Answer: C
NEW QUESTION 96
Refer to the exhibit:
Which statement supports QPPB implementation?
- A. QPPB policies affect only egress traffic
- B. QoS policies are identified in the MPLS forwarding table
- C. QoS policies rely exclusively on BGP attributes to manipulate traffic
- D. QoS policies use BGP to gain full coverage on the network.
Answer: C
NEW QUESTION 97
Refer to the exhibit.
An engineer implemented OSPF neighbor relationship on an IOS device. Which configuration must be applied to get the OR/BOR election removed from interfaces running OSPF?
- A. ip ospf network multipoint-point on interfaces running OSPF
- B. ip ospf network point-to-point on interfaces running OSPF
- C. ip ospf network broadcast on interfaces running OSPF
- D. ip ospf network non-broadcast on n:erfaces running OSPF
Answer: B
NEW QUESTION 98
Refer to the exhibit:
Which configuration prevents the OSPF neighbor from establishing?
- A. mtu
- B. network statement
- C. duplex
- D. default-metric
Answer: A
NEW QUESTION 99
Refer to the exhibit:
P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.
Which statement about the architecture is true?
- A. To support seamless MPLS. TDP must be used as the label protocol
- B. If each area is running its own IGP. BGP must provide an end-to-end MPLS LSP
- C. If each area is running its own IGP. the ABR routers must redistribute the IGP routing table into BGP
- D. To support seamless MPLS, the BGP route reflector feature must be disabled
Answer: B
NEW QUESTION 100
Refer to the exhibit:
Which effect of this configuration is true?
- A. The two routers fail to form a neighbor relationship because they have different ISIS area types.
- B. The two routers fail to form a neighbor relationship because their system IDs are different.
- C. The two routers successfully form a neighbor relationship
- D. The two routers fail to form a neighbor relationship because the authentication configuration is missing
Answer: C
NEW QUESTION 101
Refer to the exhibit:
Which configuration prevents the OSPF neighbor from establishing?
- A. mtu
- B. network statement
- C. duplex
- D. default-metric
Answer: A
NEW QUESTION 102
Refer to the exhibit. An engineer is reviewing the BGP configuration. Which router must be advertised to
10.10.10.1?
Refer to the exhibit. An engineer is reviewing the BGP configuration.
Which routes must be advertised to 10.10.10.1
- A. All routes whether local or from other ASNs are permitted.
- B. All routes whether local or from other ASNs are denied.
- C. Local routes are permitted, and routes from other ASNs are denied.
- D. Local routes are denied, and routes from other ASNs are permitted.
Answer: A
NEW QUESTION 103
Which OoS model allows hosts to report their QoS needs to the network?
- A. IntServ
- B. MQC
- C. DiffServ
- D. CB-WFQ
Answer: D
NEW QUESTION 104
Refer to the exhibit:
If router A is the RP, which PIM mode can you configure so that devices will send multicast traffic toward the RP?
- A. BIDIR-PIM
- B. PIM-SM
- C. PI MM-DM
- D. PIM-SSM
Answer: A
NEW QUESTION 105
How can shared services in an MPLS Layer 3 VPN provide Internet access to the customers of a central service provider?
- A. The CE router can establish a BGP peering to a PE router and use the PE device to reach the Internet
- B. Route distinguishes are used to identify the routes that CEs can use to reach the Internet
- C. The customer VRF uses route targets to import and export routes to and from a shared services VRF
- D. Static routes on CE routers allow route leakage from a PE global routing table
Answer: C
NEW QUESTION 106
Refer to the exhibit:
This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?
- A. It is used to create a subscription to specify the streaming interval
- B. It is used to create a sensor-group and has a list of YANG models for streaming
- C. It is used to identify MIB entries and has a list of YANG models
- D. It is used to identify traps for SNMP polling
Answer: B
NEW QUESTION 107
Which statement about TLS is accurate when using RESTCONF to write configurations on network devices'?
- A. It is provided using NGINX acting as a proxy web server
- B. It is used for HTTP and HTTPS requests.
- C. It requires certificates for authentication.
- D. It is not supported on Cisco devices
Answer: C
NEW QUESTION 108
Refer to the exhibit:
In which way does router R1 operate differently than router R2?
- A. R1 sends LSA types 5 and 7, while R2 sends type 1, 2, and 7 LSAs
- B. R1 sends LSA type 2 only and R2 sends LSA type 1 only
- C. R1 sends LSA types 1 and 2, while R2 sends type 1. 2. and 7 LSAs
- D. R1 sends LSA type 2 only, while R2 sends type 1 and type 7 LSAs
Answer: C
NEW QUESTION 109
Refer to the exhibit:
Which statement describes this configuration?
- A. Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session
- B. Router 1 can be remotely managed by the CLI using Telnet
- C. Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration
- D. Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only
Answer: C
NEW QUESTION 110
......
Candidates for the Cisco 350-501 Exam
The candidates who should take the Cisco 350-501 exam occupy different positions such as network administrators or engineers. Also, it is helpful for system engineers and network managers. Another category of the target audience for this test is formed of network designers and project managers.
The exam-takers will have 120 minutes to answer the questions included in the test. Nonetheless, Cisco doesn’t give too much information on the process itself. However, the candidates should expect to find multiple-choice and multiple-answer as well as drag and drop questions. In any case, its difficulty level is quite high, which means that students should be thoroughly prepared.
For more info read reference:
Step by Step Guide to Prepare for 350-501 Exam: https://passcertification.preppdf.com/Cisco/350-501-prepaway-exam-dumps.html